森井除湿机官方资料

You may use a hose with an inner diameter of 12 mm for

continuous drainage :

1. Use a screwdriver or so to remove the knockout at the

back, then push the hose to a connector inside the hole .

2. The hose should go down smoothly with no bends .

1. When the bucket is full, "WATER FULL" lights and the machine stops.

2. Don't remove the bucket immediately as the machine is still working or juststopping. This might cause some water dripping.

3. To remove the bucket, first pull it out, then lift carefully.

4. After each time pours water, please flushes the bucket with the clear water cleanly,in order to avoid scaling.

5. It will continue running while the bucket is restored in right position. Then close thedoor.

To incline

To liftTo restore

The compressor will restart at least 3 minutes after it stops for self-protection.You canturn on the unit immediately without waiting 3 minutes and save your time.

本文来源：https://www.bwwdw.com/article/vcvj.html