2SGen 固态发电机项目详细资料 - 图文

2SGen 固态发电机项目详细资料

配合xtdwen的视频，网上找到好多资料汇聚于此，大家探讨；我试着翻译下，能量海请校正；

xtdwen的视频喜欢追求连续性，弄得我不好意思回复；本帖希望大家热烈讨论，最好把自己实验数据，实物图照片都传上来；

视频：http://bbs.soopu.net/forum.php?mod=viewthread&tid=4764&extra=&page=1

2SGen v1.0 is an amazing Solid State Generator very simple to build, you will observe some very interesting results about the properties of a toroidal coil with a ferromagnetic core when it is used with a neodymium magnet

/ 2SGen V1.0 是一个了不起的固态发电机，非常容易制作，你将观察到配合钕磁铁的铁氧体环形线圈的许多有趣的结果；

The toroidal coil uses a ferromagnetic core (grade 3E25) specific inductance Al=3820 (23x14x7 mm) (μ=6000), Rdc:1.4 ohms,

and it is wound CW with 7.5 m of 4/10 mm copper wire,

The magnet is a 10 mm diameter and 5 mm thick neodymium magnet,

The output coil is a air core flat coil (OD: 42, ID:18mm, TH: 8mm) inductance=636 mH, Rdc=990 ohms made with 450m of 0.1 mm diam copper wire

/环形线圈绕在一个磁环上，磁环材质是 3E25 ，Al值=3820 （尺寸 23x14x7mm） (μ=6000),线圈直流电阻1.4欧姆，用线径0.4mm铜线7.5米顺时针绕制；磁铁是直径10mm 厚5mm的钕磁铁；输出线圈是一个扁平的空心线圈（外径42mm，内径18mm，高8mm）电感量=636mh，直流电阻990欧姆，用0.1mm铜线450米绕制；

磁环材质3E25的特性参数如上； 详细参数见文件：

3E25datasheet.pdf (35.23 KB, 下载次数: 37)

The neodymium magnet is simply sticked magnetically on one side of the toroid... 钕磁铁简单的吸在环的一边。。。

电路图如下：

Whether the 2SGen powers the High Power Leds lamp or not, the measured current through the toro?dal stator coil remains the same...

2SGen第三版的脉冲波形

2SGen 工作区（桔色区域）

2012-4-12 00:48:39 上传 下载附件 (110.55 KB)

With the Nanoperm core, when the magnet is placed on the top of the 2SGen, the drop of the DC current at the input is greater than with the ferrite core... Woow...

换上了纳米磁芯，当磁铁放在2SGen 的顶上时，输入的直流电流要比铁氧体材质的磁芯下降很多。。。Woow。。。

本帖最后由ruima于 2012-4-12 01:03 编辑

2SGen Episode 5: Towards more power with a new magnet/toro?d setup（改变磁铁的放置位置增加输出功率）

2012-4-12 00:56:51 上传 下载附件 (45.92 KB)

Above the new 2SGen setup: the neodymium magnets have been placed in the center of the toro?d so has the magnetic lines are closed inside the toro?dal core.

2SGen 钕磁铁新的放置方法：磁铁放在磁环中间，使磁铁的磁力线通过磁环闭合；

With this new setup, there is more OUTPUT power without change at the input. 新的放置方法，增加了输出，输入功率没有变；

本帖最后由ruima于 2012-4-12 10:52 编辑

2012-4-12 10:48:13 上传 下载附件 (122.64 KB)

The toro?dal 2SGen coil has also been fully inserted in a cylindrical air coil. 2SGen 磁环线圈也可以完全插入一个柱状空心线圈里

WOOW... The POWER OUT is greatly magnified without any change in at the input of the DC power supply...

输入功率没有变化，输出功率却大大增加

Now, with the 2SGen V5, I am able to power higher power leds panels... 现在，用 2SGen第五版，我能使更高功率的Led板点亮；

2SGen Episode 6: The 2SGen hidden principle: The energy from the core magnetization/demagnetization process（2SGen 隐藏的规律：能量来自于磁化/退磁过程） In the scope pictures below:（在下面示波器图片里）

the yellow curve is the pulse sent by the controller to build up the magnetic field of the core (magnetization phase), （黄色曲线是控制器送过来的用于建立磁环磁场的脉冲波形磁化阶段）

the blue curve is the pulse measured across the output coil connected to a lamp as a load.（蓝色曲线是输出线圈连接一个灯泡负载所测波形）

2012-4-12 11:00:11 上传 下载附件 (155.78 KB)

Look at the blue curve, the first part (negative curve) is the magnetization phase of the core (building up of the magnetic energy), you may notice some Barkhausen effect bumps.

The second part (positive curve) is the demagnetization phase of the core. The excess free energy is tapped during the demagnetization process and not during the magnetization process due to the blocking diode connected at the output coil. To get more free energy from the 2SGen device, the clock pulse must be shorter as possible (during the magnetization process).

The process of free energy generation from magnetization/demagnetization of a ferromagnetic core has been fully explained in the Nikolay E. Zaev paper \Ferrites and Ferromagnetics Free Energy Generation\看蓝色曲线，第一部分（负的曲线）是磁芯磁化阶段（构建磁场能量），你会注意到一些Barkhausen效应的颠簸。第二部分（正的曲线）是磁芯的退磁阶段。由于阻隔二极管连接在输出线圈，额外能量在退磁阶段提取而不是在磁化阶段。要想从2SGen设备中提取较多能量，时钟脉冲必须尽可能的短（磁化阶段）。从铁磁磁芯的磁化/退磁过程中提取自由能量在Nikolay E。Zaev的论文“铁氧体和铁磁体自由能源的产生”有全面的阐述，这篇论文出版在

Sept-Oct 2002期《新能源技术》杂志上。论文下载：9)

2012-4-12 12:30:51 上传 下载次数: 9

demag.pdf (138.83 KB, 下载次数:

2012-4-12 11:02:03 上传 下载附件 (155.53 KB)

The pulse period must be greater than the time of the magnetization/demagnetization process, here 1500 μs.

脉冲周期必须大于磁化/退磁过程所用的时间，在这里是1500us 22#

Some important keys to get an excess of energy:

The output coil must be fully EM decoupled from the input coil (no mutual inductance), so this why the toro?dal coil is used as the input coil and a cylindrical or a flat coil set at 90° as the output coil.

The magnet is used only to set the operating point in the MH curve of the toro?dal core. The

（奇怪，高功率版本在Jean的网站不提供资料了？？？难道是师傅领进门，修行在个人本帖最后由ruima于 2012-4-13 22:57 编辑

这是一个国外复制者详细资料和测试结果http://freenrg.info/Some_Experiments/JLN_2SGEN/ 我会陆续搬上来；奇怪的是该复制者最后得出下图结论

）

放进去钕磁铁=？短路线圈

是不是很疯狂？

本帖最后由ruima于 2012-4-13 23:37 编辑

刚才简单的测试了下，很有意思，加了磁铁，消耗电流下降很大，同时扁平线圈有了输出，我不愿意使用Led当负载，所以使用了一个12V5W的白炽灯，居然能点亮（不是全功率），还有一个现象是磁铁磁极反过来，输出脉冲也反向，不加磁铁是没有输出的；进一步的详细测试正在进行中。。。。。到时我会把详细数据波形图陆续传上来，不管怎么说，这是一条路，得走走试试，这是一种新的发电方法，了解了机理后，看能否做个几百瓦的

也顺便测试了楼上的图，我的结果是两种结构并不相等；

期待大家的复制和讨论；

本文来源：https://www.bwwdw.com/article/s7ov.html